Recent content by bizentech

If there is no hard reset button then the only other option is the SD Card slot or using the serial port. I don’t know how to do the serial port version. Make sure you have the correct firmware for the A series. Honestly it should work. You must be doing something wrong. Put SD card in with...

nope! Just upload the FIRMWARE FILE ONLY to the SD card, no folders or sub folders or other content. Just the single file, place SD card into doorbell, power up and Doorbell will pull new firmware. Once it is complete, it will reboot, at which point, remove the SD card so it doesn’t do the...

So, for example: virtual host on NVR assigned static IP: 192.168.1.200 Gateway:192.168.1.1/24 DB assigned static IP: 192.168.254.2 PoE gateway: 192.168.254.1/24 Home router: 192.168.1.1/24 so, static route has to between 192.168.1.1 and 192.168.254.1? Can I just do a static route between...

Hello all, I have my DS-KV6113 Doorbell connected behind my NVR (so it can also record to NVR) but i cannot get the doorbell to ring. It always says "calling failed". I have my push notifications enabled on the app, but i have a feeling it has something to do with communicating out of the POE...

I resolved the issue with the firmware upgrade, although motion detection notifications seem to not be all there. I’ll keep testing it

So the Doorbell camera works and all. Video, Calls Phone, records to NVR, etc but when button is pressed and I answer the phone to see who it is, the video feed comes up as “Network Unstable” but the 2 way audio works and buzzer (if it existed) works as well everything is hardwired, Not...

TFTP never initialized. Same with the RS232 serial interface. Idk maybe I was doing something wrong but it’s still fixed nonetheless

We’re you able to resolve this issue? I am experiencing the same issue with my Hikvision doorbell camera

Yes, DB Camera went back to inactivate after it accepted the firmware. TFTP and/or telnet did nothing. Only option was the SD card slot. Was easy and worked flawlessly

Disregard! Worked with just uploading the digicap.dav firmware onto a blank SD card, inserted it into the doorbell camera, powered it up, and boom! Uploading! apparently the upload deactivates everything (good in my situation) but could be a potential security flaw because outside has access to...

Hello, I accidentally loaded old or incompatible firmware to my KV6113 Door Bell. May have been version A or something, i dont know. But after the upgrade (well, downgrade) I am unable to log into the device. Yes, I am able to access a login screen but my set password (and other potential...

Hey, I also bricked my doorbell because I loaded older firmware. Will attempt to load onto an SD card and see what happens. does anyone have a firmware link? I am unable to find any 200804 or younger firmware. Thanks