Left field but just in case you also missed this, you also need:
1. a reasonable monitor to appreciate the full resolution of some cameras
2. to set your nvr to output the correct resolution to suit your monitor
@David and @Dan thanks for the suggestions.
I went through a few combinations of firmware reloads and resets with no luck until I finally remembered the old trick of removing the power supply cable for a good half hour. After this it booted back up with correct date and recording to the HDD...
Thanks
@David - I have already tried setting up an NTP server. On the NVR nothing appears to change, via IE it says "Invalid Operation" on save.
@Dan - I assume hard reset means factory reset on NVR? I tried this but the time was still showing 1970 even at the setup pages. I have lost a couple...
Hi All,
I have a DS7608NI-I2/8P that suddenly stop recording last October. Before this it was happily overwriting the 5TB HDD.
I've enjoyed reading through past posts looking for a solution to this one and have managed to get up to date on firmware, V4.60.000 build 211129, but that's it...