Recent content by jimprince2k

I bought a Hikvision DS-2DE4425IW-DE PTZ camera. I connected the given 12 V power adapter and Network cable to the Hikvision NVR through a switch(Not POE). Camera turned on and worked fine for around an hour. After that it went offline. I checked the power adapter output and I could see 12V...

Do you have any idea if I can tell that the camera I have correctly supports h 265? The camera web GUI has these settings for selection. Can ONVIF device manager help in identifying this?

I would try your recommendation on using the alternate port for mouse. Regarding the codec recommendation, I already faced one problem. While installing I accidentally set a few of the cameras as H264 and rest of them as H265. After a week I noticed that only those cameras that are set with H264...

Thanks for your reply. I have rebooted the NVR at least once in a week. I dont think that is solving my issue. I haven't looked into the logs I will do that this weekend to see if I can find something relevant. Btb I forgot to mention one more problem. I used to check the NVR display once in a...

Firmware seems to be latest. It is showing as 3.4.104 build 190128

I have installed a DS7600(ds-7632ni-k2) series NVR with 9 IP third party cameras(supports onvif). Among the 9, I have set 8 cameras to be recorded with continuous mode and for 1 camera I have set motion detection. The nvr started recording after recognizing a motion. Also I could see the yellow...