Recent content by metroman

Regarding getting notifications when any activity is detected in the area that has been setup on the camera, in that regard nothing has changed. I.E. Enter the your email details in the task management area on the camera, access the camera using the WAN I.P address Example ??.??.??.??:8150, It...

I agree its not been helpful with the ucam app no longer functioning , but it was far from perfect. Pic below showing nine of my cams in different countrys & locations using the IPcam app, and even though it is a little more difficult to make changes to the camera settings, the cameras are far...

Also Put 8150(1)(2)(3) depending on how many cameras you have up in the port section of the app

As your phone has a dynamic I.P., to access your camera remotely you will have to subscribe to a dns service, which will keep track of the phones changing IP. So you would put something like mycamera.dyndns.me in the remote section of the app, and register the current I.P. with the dyndns server...

If you can access any of your cameras using the ucam247 app, then go advanced setting and the remote IP will be shown along with the local IP. But you are quite correct stating the IP will change should the router reboot’s and will require a VPN or DDNS to enable you to have a static IP

I have only been using the app for the last 24hrs, and just getting my usual email alerts, which are virtually instantaneous when there is activity is detected. So I think it is best you visit the web site www.ubntek.com which has a lot of information as to what the app can achieve

Sorry its www.ubntek.com

It is available for both apple & andriod If you go to their web site www.ubtek.com the app as it is the third one down from the top. Should you require any further help please do not hesitate to ask. It certainly has been a life saver for me, did not fancy having to replace all the cameras...

Yes you can access the camera's, however you will need to know the IP address of the router/camera in Portugal, then its just a case of putting that info into the app, and the port # of the camera Hope this helps

I have over 20 ucam247 camera's in different locations, and initially thought the problem as to why I could not access the cameras remotely was some fault with the router's until I came across this forum, and found the information here very useful. However I tried using some of the apps...